Cherry Blossoms Set 1 Large Silicone Mold by Zuri Designs
Cherry Blossom Set 1 (for furniture artists and large-scale mixed media pieces) Silicone Mold by Zuri Designs Vintage Dreams Collection
Mold Size: 16.14" (41cm) x 11.1" (28.2cm) x 0.32" (0.82cm)
Individual castings vary in size, with the largest element being approx. 8 inches in length.
Delicate yet striking, Cherry Blossom captures the quiet poetry of petals caught mid-bloom. Every branch in this set—whether curved with budding softness or blooming in full—feels alive with movement, detail, and tenderness.
Set 1 is ideal for furniture artists, wall panels, or larger-scale mixed media creations, where impact meets grace.
Cast them in clay, resin, plaster, or wax—paint them with pastels or metallics. However you bring them to life, they’ll carry the same message: Even fleeting beauty can leave a lasting mark.
Whether used for a romantic vignette or a timeless heirloom, the magic of these blossoms never fade.
Cast them in clay, resin, plaster—paint them with pastels or metallics. However you bring them to life, they’ll carry the same message: Even fleeting beauty can leave a lasting mark. Whether used for a romantic vignette or a timeless heirloom, the magic of these blossoms never fade.
Perfect for mixed media artists, furniture embellishment, resin casting, journaling, or decorative trim, these designs turn simple frames, boxes, canvases, and books into heirlooms. Whether you cast them in plaster, clay, resin, or wax, the detail holds beautifully and finishes like a dream.
From opulent scrolls to symmetrical floral inlays, these borders don’t just decorate—they define.
This mold is oven safe up to 464 F (240 C), freezer safe to -104 F (-75 C) and can be safely used in the microwave. It is BPA, PVC and Phthalate free.
This mold is made of 100% food grade silicone. It is therefore suitable for use with edible mediums for candy and cookie making, cake decorating, etc. You can also use it to make ice shapes by filling the cavities with water and placing the mold in the freezer.
For instructions on how to use the above listed mediums and the use of release agents, please refer to their respective manufacturer’s instructions.
How to use our molds: When appropriate, apply a release agent to the surface of the mold in a fine, even layer. Fill the mold with your medium and allow to cure. Gently bend along the edges of the mold to release the casting. Remove the casting with care, without any forceful pulling or excessive bending. Certain mediums with higher water content and/or elasticity may tend to stretch with the mold when attempting to remove, making it more difficult to separate them from the mold. If that happens, simply place the mold in the freezer for about 30 minutes. The casting will then pop right out.